They seem to make lots of good flash cms templates that has animation and sound.

[ Pobierz całość w formacie PDF ]

ÿþSPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL
BMW SERIE 7 03 ’! DIESEL
’!
MAKE MOD. YEAR
X
ALARM/SIREN Position the compact alarms and the sirens in the engine compartment.
POSITION
Position the modular sistems and the modules under, on the left of the dashboard, driver s
CENTRAL UNIT POSITION
side.
POWER SUPPLY +30: connect directly to the big wire coming out of the battery terminal. It is suggested such
connection as some connections with fixed supply are deactivated by the electronic system of
the vehicle after about 30 min. from the extinction of the switchboard.
-31: connect with a cable terminal directly to the ground terminal located behind the driver s
side sill cover.
IGNITION WIRE +15/54: connect to the BLACK/RED wire, at the position nr. 19 coming out of the 32 way black
connector of the  battery cut out central, in the passenger s side boot. As alternative
connect to the 1,5mm2 GREEN/BLUE wire located in the wiring harness behind the driver s
side sill cover.
DIRECTION INDICATORS Connect to the wires: BLUE/GREEN pos. nr.4 for the driver s side front door, BLUE/BROWN
pos. nr.1 for the passenger s side rear door, BLUE/BROWN pos. nr.24 for the passenger s
side front door, BLUE/GREEN pos. nr.55 for the driver s side rear door, located in the 88 way
black connector coming out of the lights operating central located on the left of the steering
column. It is suggested to separate the lines by means of 4 diodes.
ELECTRIC WINDOWS Positive control signal
Doors and windows Comfort locking
Connect to the BLUE/RED wire at the position nr.7 (lock) and to the WHITE/BLACK wire at the
position nr.9 (unlock), located in a 18 way black connector, directly on the coming out of the
push-button panel inside the driver s side door.
CENTRAL DOORS LOCKING Negative control signal
Connect with both the (VIOLET and ORANGE) wires of the antitheft to the YELLOW/RED wire
at the position nr.24, of the 26 way white connector, directly coming out of the central locking
unit located behind the passenger s side glove compartment
IMMOBILISATION POINT 1 Gasoil pump
Cut the BLUE/BLACK wire, in the 13 way black connector, of the white central located behind
the passenger s side glove compartment.
IMMOBILISATION POINT 2 General ignition wire
Cut the BLACK/YELLOW wire in the connector coming out of the ignition key.
STARTER +50: Cut the 2mm2 BLACK wire located in the wiring harness coming out of the MOTRONIC
central placed in the lower part of the antipollen filter, in the engine compartment.
BONNET SWITCH Connect to the wire coming out of the lamp directly in the bonnet/engine.
DOORS SWITCH NOTE: the polarity is positive. Invert the signal with an additional relay. Connect to the
RED/BLUE wire located in the wiring harness coming out of the lamp of the driver s side
rudder pedals. As alternative: at the position nr.20, in a black connector of the white central
located behind the passenger s side glove compartment.
BOOT SWITCH Connect to the YELLOW/BLACK wire, at the position nr.19, of the 26 way white connector,
directly coming out of the white central placed behind the passenger s side glove
compartment.
bmse703gbd.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual. [ Pobierz całość w formacie PDF ]

  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • docucrime.xlx.pl